Installation Prerequisites - Enel X JuiceBox Bedienungsanleitung

INSTALLATION PREREQUISITES

JuiceBox requires a hardwired electrical connection that is rated
to at least 125% of the device's continuous load. JuiceBox must
be be installed by a qualified electrician. An external enclosure
rated at IP66 shall be used to house the connection between the
JuiceBox input cable and the AC supply circuit.
NOTE: Ensure that all power connection wiring conforms to the rules and
regulations of any national and local codes.
Device Protection: JuiceBox requires a dedicated overcurrent
protection device that includes both a Curve D MCB (miniature
circuit breaker) and Type A RCD (Residual Current Device).
When selecting a location to install the hardwire connection, keep
in mind that the charging unit should be positioned:
Within reach of the vehicle's charge port
0.5m - 1.5m above the floor or ground
If applicable, within range of a cellular connection or the local
WiFi network
4