Herunterladen Diese Seite drucken

HAPRO TOPAZ Anleitung Seite 4

24c-24/1c
Vorschau ausblenden Andere Handbücher für TOPAZ:

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 5
ENG
(original instructions)
Assembly instructions
Before your appliance leaves the Hapro plants it is tested thoroughly and inspected for defects and damage. We request you when opening
the packaging to always check the appliance for external defects, imperfections or transport damage. Should it regrettably display defects or
omissions, please contact your dealer.
Your appliance should be installed carefully using these assembly instructions. You should also check whether the local power supply
corresponds to that stipulated on the type panel that is stuck to the back of your appliance.
We advise you not to use an extension cable, unless its electrical rating meets the requirements of the application. If the supply cord is
damaged, it must be replaced by the manufacturer or service agent or a similarly qualified person in order to avoid a hazard.
Do not place your appliance in a damp area and make sure that there is adequate ventilation. When in doubt consult your dealer.
After you have installed your appliance you should check that everything is functioning properly. The following options apply:
a.
When your sun bed is fitted with an electronic operating section (can be identified from the digital display), you can test the
appliance on the basis of the accompanying instructions.
b.
When your appliance is fitted with an electromechanical timer (can be identified from the turning knob or pointer), you can test the
appliance by turning the knob clockwise. The appliance can be switched off again by turning the pointer or knob back to "0".
Note: Before the end of the tanning session, the machine will give a series of bleeps to alert you.
Usage
When your appliance is properly installed and functions properly it is ready for use.
Caution: before actually tanning you should familiarize yourself with the information in the accompanying booklet "sunny prospects".
Defect
When your appliance does not operate as expected this may be due to a disturbance and/or defect. Before reporting this problem to your
dealer you should check whether the unit has been properly installed. The following situations apply:
a.
Mechanical defect. Check whether your appliance has been properly installed by once more reading the assembly instructions.
b.
Electrical defect. Try to correct the defect using the trouble-shooting guide below.
Note: Do not use your appliance when the ventilation is defective or is not functioning optimally, the timer is defective or the blue and/or
white filter glass of the optional face tanner is broken or missing.
Problem
The appliance does not start.
The fuse blows in use
Some lamps do not burn
Lamps burn dimly when the unit is
not in use
*When replacing parts you should always use original parts. Inquire for those with your dealer.
4
Possible solution
a. Check that the plug is properly connected to the wall socket power supply
b.
Check that power is being supplied to the wall socket
a. Check the rating of the fuse. This should be: 16A slow
a. Check for the lamp(s) involved the starter and switch using where necessary the starter from a
lamp that is functioning.
b. Check the de lamp(s), by swapping those that do not work with those that do.
a. Reverse the switch to the power cable.

Werbung

loading

Diese Anleitung auch für:

Topaz 24cTopaz 24/1cTopaz 12vTopaz 10/1v