Switching The Led Lamp On And Off; Third Hand; Soldering Sponge; Fitting The Spindle Rolls - Parkside PLLL 16 A1 Bedienungsanleitung

♦ Put the battery holder back in the battery com-
partment and ensure that you observe the
correct polarity.
♦ Close the battery compartment.
NOTE
► Do not mix old and new batteries. Always
replace all batteries at the same time, as
otherwise the batteries discharge each other.
Always use batteries of the same type and
brand.
NOTICE!
► Do not leave used batteries in the appliance,
as even leak-protected batteries corrode and
chemicals can be released, which can dam-
age your health or destroy the appliance.
Do not leave batteries lying around unat-
tended. They might be swallowed by children
or pets. Consult a doctor immediately if they
were swallowed.
► If you do not plan to use the appliance for
an extended period, remove the batteries to
prevent leakages.
► Leaking or damaged batteries can cause skin
irritations if touched. Therefore, wear suitable
gloves in that case.
► Ensure that batteries cannot be short-circuited.
Do not throw batteries into a fire.
► Do attempt to recharge non-rechargeable
batteries. There is a risk of explosion.
Switching the LED lamp on and off
■ Switch the magnifier lamp
off switch on the base of the lamp foot.
Switching on:
♦ Set the on/off switch to "I" to turn on the magni-
fier lamp.
Switching off:
♦ Set the on/off switch
magnifier lamp .
♦ To protect the magnifier lamp
magnifier cover .
PLLL 16 A1
on using the on/
to "O" to turn off the
, fit the supplied
NOTE
► Avoid touching the magnifying glass with
your finger nails or other sharp objects.

Third hand

CAUTION! RISK OF BURNS!
► The crocodile clips
during use.
♦ Flip the third hand
♦ Turn the crocodile clips
tion.
♦ Clamp the workpiece between the two crocodile
clips.

Soldering sponge

NOTICE!
► The hot soldering tip
contact with a dry soldering sponge
Otherwise, the soldering sponge can be
damaged.
NOTE
► The soldering sponge is used to clean the
soldering tip.
► Dampen the soldering sponge before use.

Fitting the spindle rolls

♦ Select the correct diameter of spindle roll
onto which you want to fit the solder roll.
♦ Place the spindle roll on the solder coil mount
and guide the solder wire through one of the
three holes in the solder guide
can get very hot
upwards.
in the desired direc-
must never come into
.
.
GB
IE
7