Vitek VT-2326 VT Die Betriebsanweisung Seite 5

•
Note: During the first operation some
foreign smell and a small amount of
smoke from the heating element is
possible, this is normal.
•
Hair care
To get the best results, wash your hair
with shampoo (before drying and styl-
ing), remove excessive moisture with a
towel and comb your hair.
Quick drying
Set the switch (1) to the position «1» or
«2» and dry your hair. Shake off exces-
sive moisture from the hair with your
hand or a comb and constantly move
the hairdryer above your hair.
Straightening
Set the switch (1) to the position «1» or
«2» and dry your hair. When the hair is
almost dry, switch the unit off. Attach
the nozzle (3) to the hairdryer and then
set the switch (1) to the position «1».
Divide your hair into locks, start
straightening from lower layers. Using
a plain or a round brush, comb the
hair downwards and simultaneously
direct hot air at your hair. This way,
slowly straighten each lock from root
VT-2326.indd 5
Use the switch (1) to set the
required air supply speed:
«0» – the hairdryer is off;
«1» – low air flow speed and low
temperature;
«2» – high air flow speed and high
temperature.
This model has a "cool" air supply
function, use it to fix your hairstyle.
For «cool» air supply, switch the
hairdryer on and then press and
hold down the button (2)
to end. After you finish straightening
the lower locks, start straightening
the middle locks and finish with the
upper locks.
Natural locks
Set the switch (1) to the position «1»,
grip locks between fingers tightly, turn
them in the direction of natural curl-
ing. Dry your hair, directing the airflow
between fingers. To fix the styled lock,
direct cold air flow at the lock. To do
this, press and hold down the button
(2) .
. Styling
Attach the nozzle (3) to the hairdryer
and then set the switch (1) to the posi-
tion «1».
Divide your hair into locks and create a
required hair style by means of a round
hair-brush. During hair styling, direct
the air flow straight at your hair.
If you want to fix the hairstyle, direct the
cool air flow at each lock for 2-5 sec-
onds. Styling time is determined indi-
vidually according to hair type; you can
determine it by yourself.
Overheating protection
Overheating protection switches the
hairdryer off if the outgoing air is
too hot. If the hairdryer has been
switched off during operation, set the
switch (1) to the «0» position, unplug
the hairdryer and make sure that the
inlets and outlets are unblocked. Let
the hairdryer cool down for 5-10 min-
utes and switch it on again. Do not
block the air inlets during unit opera-
tion and avoid getting of hair into its
air inlet.
5
ENGLISH
25.12.2014 10:45:55