Sharp DF-A1E-W Bedienungsanleitung Seite 12

11
Description of the Aroma Diffuser
1 Main Parts of Your Aroma Diffuser on page 1).
(Refer to the
Your Aroma Diffuser consists of the following parts:
1. Power Cable
2. AC Adaptor
3. Power input
4. Lid
5. Water Cup
6. Maximum mark
7. Ultrasonic Membrane
8. On/Off button
9. Light control button
10. Air outlet opening (When filling make sure that no water
enters this opening)
11. Fan
Controls
On/Off button (item 8)
To turn the unit on and off use the
the side of the unit and requires a simple push to turn on. When
the button is pressed it will click. Press once to turn on, press
again to turn off.
Light button (item 9)
It is possible to control the intensity of the light by pressing the
light button. This button operates as below if the light is on.
1. Press once – light dims.
2. Press again – light turns off.
3. Press again – light turns on at maximum level.
4. Pressing the button repeats 1 to 3 as above.
Top tips and hints
For trouble free use of your SHARP Aroma Diffuser, follow
the advice in this user manual and the bullet points below:
• DO NOT block the fan grill as this will cause the mist not to be
emitted correctly.
button this is located on
• Fill the cup to the maximum water level prior to use and
when being used with the Auto Restart function.
• Make sure that the lid is always fitted correctly.
Using your new Aroma Diffuser
Before filling your Aroma Diffuser with water, either turn off via
the button on the front or disconnect from the mains supply.
Fill the water cup to the maximum mark indicated. Do you not
exceed the maximum mark as this will cause the Aroma diffuser
not to operate correctly and cause spillage of water.
This Aroma Diffuser is designed to be used with clean water,
ideally this should be distilled water or if this is not available
you can use clean tap water. Once the cup has been filled to the
maximum level essential oils can be added to the water. Be sure
to follow the essential oil instructions to ensure that the correct
amount is used.
2 Water Level Mark on page 1).
(Refer to the
Replace the lid, ensuring that it is correctly aligned and fitting
snugly into the base of the unit. If the lid is not installed
correctly there will be a gap between it and the base which will
allow water to drip down the side of the unit. If the lid does not
fit correctly rotate and try again.
3 Correct Fitment of Lid on page 1).
(Refer to the
Once the lid has been correctly fitted, it is possible to turn
on the unit. To do this press the on off
the side. The unit will power up and the LED will be at full
brightness.
Connecting power to your Aroma Diffuser
Your new SHARP of Aroma Diffuser works with an external AC
adapter. It is important that this AC adapter is kept away from
any water and is not operated or touched if your hands are wet.
Your AC Adaptor plugs into the mains supply and then is
connected to the Aroma Diffuser via the power cable, This
lead has moulded connectors on each end; the USB connector
plugs into the AC Adaptor; the round plug fits into the Aroma
Diffuser.
button located on