Important Safety Information; English - Honeywell FH-971E Gebrauchsanweisung

IMPORTANT SAFETY INFORMATION

Read all the instructions through before starting
to use the fan heater. Keep this user's manual
safely for future reference.
1. Install the fan heater in a location that is
inaccessible to children.
2. Do not operate the fan heater outdoors.
3. Place the fan heater on a firm, even surface.
Make sure the fan heater is standing secure-
ly so that it cannot tip over all fall off. The
fan heater should only be operated in an
upright position.
4. Unwind the power cable completely, i.e.
pull the cable completely out of the cable
storage space. If the power cable is not
completely unwound or pulled out this could
lead to overheating and cause a fire.
5. Do not use an extension cable or an infinitely
variable speed regulator, as this could lead
to overheating, a fire or an electric shock.
6. The fan heater must be connected to a
single-phase plug with the voltage as stated
on the type plate of the appliance.
7. Always disconnect the plug from the power
supply when the fan heater is not in use, or
when it is handled, moved, or cleaned. Do
not tug at the cable to unplug the appliance.
8. Do not operate the fan heater anywhere
near inflammable gases or substances such
as solvents, paint, glues, etc.
9. Do not install the fan heater directly beneath
a power socket.
10. Do not use the fan heater in close proximity
to a bathtub, a shower or a swimming pool.
11. Do not use the fan heater in any kind of
transport vehicle (e.g. construction vehicle,
elevator, lift, caravan, automobile, cabin) or
similar enclosed space.
12. Warning: The air exhaust opening (2) of the
fan heater gets hot during use (over 80 °C
/ 175 °F). Burnable materials such as cush-
ions, duvets, bedding, furnishings, paper,
curtains, and clothing must be kept at least
100cm away from the fan heater.
13. Keep the fan heater clean. Before operating
the fan heater, make sure that the air intake
vent (11) and the air exhaust vent (2) are
open. No objects must be allowed to get
into the air intake (11) or air exhaust (2)
openings. Do not cover up the fan heater
( at the front of the fan heater), as
this could lead to overheating, fire or an
electric shock.

ENGLISH

14. Do not immerse the fan heater in water
or any other liquids and do not spill water
or any other liquid onto the appliance or
into the air intake (11) or air exhaust (2)
openings.
15. Clean the fan heater regularly, paying
attention to the cleaning instructions.
16. If the power cable (12) of the fan heater is
damaged it must be repaired by a work-
shop approved by the manufacturers, as
special tools are needed.
17. Do not start operating the fan heater if it is
damaged or shows any signs of damage,
or if it is not functioning properly.
Disconnect the plug from the power supply.
CONSTRUCTION
1. Safety distances
2. Air exhaust vent
3. Rotary power switch
4. OFF (O)
5. Cold air ( )
6. Warm air 1000 W ( )
7. Hot air 2000 W ( )
8. Rotary thermostat switch
9. Room temperature about + 5 °C
10. Room temperature about + 30 °C
11. Air intake vent
12. Power cable and plug
13. Cable storage space
14. Transport grip
FIRST TIME OF USE
1. Read all the instructions through before
starting to use the fan heater.
2. Unpack the fan heater and power cable,
remove all packaging materials and dis-
pose of them in an environmentally friendly
manner.
3. Place the fan heater on a firm, even surface.
Make sure the appliance is standing
securely so that it cannot tip over or fall off.
A safety distance of at least 100 cm from
other objects must be observed
Cable storage space
1. The fan heater has a cable storage space
(13). Push the power cable (12) through
the opening into the storage space, up to
the plug.
4