Additional Information; Troubleshooting; Power; Basic Operation - Yamaha BD-A1060 Bedienungsanleitung

ADDITIONAL INFORMATION

Refer to the table below when this Player does not function properly. If the problem you are experiencing is not listed
below or if the instruction below does not help, turn off this Player, disconnect the power cable, and contact the nearest
authorized Yamaha dealer or service center.

■ Power

Problem
No power.
The Player power is turned off.

■ Basic operation

Problem
The remote control does not work.
Buttons do not work.
Password is forgotten.

■ Disc playback

Problem
The disc tray does not open or close.
The Player cannot play a disc.
Video stops.
The Player makes a snapping sound
when starting playback or loading a
disc.
It takes time to start Blu-ray disc
playback.
46
En

Troubleshooting

Possible causes and solutions
– Connect the AC power cable properly.
– Press p on the front panel to turn on the power.
– This Player will be automatically turned off after 20 minutes of inactivity (no playback)
when Auto Power Standby (p. 36) is set to on.
Possible causes and solutions
– Use the remote control within its operating range (p. 11).
– Replace the batteries (p. 11).
– Check the ID settings for the main unit and the remote control. The remote control ID
on the main unit may be changed after the main unit is reset. In this case, verify the
remote control ID on the main unit, and set it again if needed (p. 11).
– Turn on the TV connected to this Player and perform the initial settings (p. 21).
– Press and hold p on the front panel for more than 5 seconds to reset this Player.
– To completely reset this Player, unplug the power cable from the AC outlet for 30
seconds or more, plug the power cable to the AC outlet again, and then turn on this
Player.
– Press and hold , and
inserted and playback is stopped to set all the settings including Security settings (p. 37)
of this Player to their default settings. After the power is turned off automatically, press
p to turn on the power again.
Possible causes and solutions
– The disc tray is locked when any network service is selected.
– The disc tray is locked when this Player is in the Miracast receiving mode. Press
Miracast to exit from Miracast (p. 27).
– Take out the disc and clean it (p. 5).
– Make sure that the disc is loaded properly (aligned in disc tray and label-side up) (p. 5).
– Use a disc supported by the Player (p. 3).
– Remove the disc and then check whether the Player supports the disc or not (p. 3).
– Check the region code (p. 3).
– Check whether the disc is defective by trying another disc.
– The CD-R/RW, DVD+R/RW/R DL, and DVD-R/RW/R DL must be finalized (p. 3).
– When this Player is in the CD-mode, discs other than music CDs and SA-CDs cannot be
played (p. 25).
– The Player will stop if it senses shock or vibration.
– These sounds are not malfunctions of the Player but are normal operating conditions.
– This player searches for a USB memory device used as Local Storage for BD-Live
feature (p. 32) when a Blu-ray disc is loaded. To reduce the waiting time, keep a USB
memory device connected to the one of the USB connectors (front/rear) of this Player
(p. 19).
on the front panel simultaneously when no disc is