Comfee MSR23 Serie Installationshandbuch Seite 17

Step 5: Connect drain hose
By default, the drain hose is attached to
hand side of unit (when you re
the left-
facing the back of the unit).
1. To ensure proper drainage, attach the
drain hose on the same side that your
refrigerant piping exits the unit.
2. Attach drain hose extension
(purchased separately) to the end of
drain hose.
3. Wrap the connection point firmly with
Teflon tape to ensure a good seal and
to prevent leaks.
4. For the portion of the drain hose that
will remain indoors, wrap it with foam
pipe insulation to prevent condensation.
5.
Remove the air filter and pour a small
of water into the drain pan to
amount
make sure that water flows from the
unit smoothly.
NOTE ON DRAIN HOSE
PLACEMENT
Make sure to arrange the drain hose
4
according to Fig. .15.
DO NOT kink the drain hose.
DO NOT create a water trap.
DO NOT put the end of drain hose
in water or a container that will
collect water.
PLUG THE UNUSED DRAIN HOLE
To prevent unwanted leaks you must plug
,
the unused drain hole with the rubber plug
provided.
Fig.4.15
NOT CORRECT
Kinks in the drain hose
will create water traps.
NOT CORRECT
Do not place the end
of the drain hose in
water or in containers
that collect water. This
will prevent proper
drainage.
CORRECT
Make sure there are no
kinks or dent in drain
hose to ensure proper
drainage.
NOT CORRECT
Kinks in the drain hose
will create water traps.
Fig. 4.17
Fig. 4.18
Fig. 4.16
Page 17