Comfee MSR23 Serie Installationshandbuch Seite 16

6. After finishing connecting the couple of the
quick connectors, pass drain hose and
refrigerant pipes through the wall hole as
shown in Fig.4.10.
NOTE:
The quick connector parts must be
placed outside of room. Using wall hole
sleeve, cap and neoprene to seal the wall
hole.
Fig.4.10
7. In order to prevent the quick connector parts
from being exposed in the air, the sound
deadening pads are supposed to be used
during the installation, see Fig.4.11.
Fig.4.11
8. Wrap up the quick connectors with the sound
deadening pads, pack down the pads solid
as tightly as shown in Fig.4.12.
Fig.4.12
Page 16
9. Then wrap up the connectors with the
black insulation material, for the top
exposed part, use the white insulation
material (supplied in Accessories box)
to wrap it up completely as shown
in Fig.4.13.
Fig.4.13
10.At last, use the tape to wrap the
refrigerant pipe and connecting
cable together.
NOTE ON PIPING ANGLE
Refrigerant piping can exit the indoor unit
from two different angles:
Left-hand side
Right-hand side
4
Refer to Fig. .14 for details.
Fig. 4.14
CAUTION
Be extremely careful not to dent or damage
the piping while bending them away from
the unit. Any dents in the piping will affect
,
the unit s performance.