Wiring And Safety Of The Built In Oven - Sharp K-50M22BL2-EU Bedienungsanleitung

If the oven is installed under a hob, the
distance between the worktop and the
top panel of the oven must be a mini-
mum of 50 mm and the distance bet-
ween the worktop and the top of control
panel must be a minimum of 25 mm.
WIRING AND SAFETY OF THE
BUILT IN OVEN
The instructions given below must be
followed explicitly during wiring:
– The grounding cable must be connec-
ted via the screw with the grounding
mark. The supply cable connection
must be carried out as shown in Fi-
gure 6. If there is no grounded outlet
conforming to regulations in the ins-
tallation environment, call the Authori-
zed Service Centre immediately.
– The grounded outlet must be in clo-
se proximity to
Never use an
–
The supply
contact the product's hot surface.
– In the event of any damage
to the supply cable, make sure to
call the Authorized Service Centre.
The cable must be replaced by the
Authorized Service technician.
– Wiring of the appliance must be per-
formed by the Authorized Service
technician. A H05VV-F type supply
cable must be used.
– Faulty wiring may damage the appli-
ance. Such damage will not be cove-
red under the warranty.
– The appliance is designed to connect
the appliance.
extension cord.
cable should not
EN - 9
to 220-240V~. If the electricity is diffe-
rent than the value given above, call
the Authorized Service Centre imme-
diately.
– The manufacturer declares that its
bears no liability of any kind for
damage and loss arising from not
complying with safety standards!