Kenwood CMOS 210 Bedienungsanleitung Seite 6

Connections
Basic Connections
Navigation system/video monitor (separately available)
Camera
Switch unit (CMOS-310 only): 1 m (3.28 feet)
Engine key
Main fuse
Battery
CAUTION
• If the engine key of your vehicle does not have the ACC position, branch the wire energized when the engine key is ON and
connect it to the accessory power cord.
• Before proceeding to connections, make sure that the engine key is not inserted and disconnect the (-) terminal of the battery
to prevent the short-circuiting incident.
6
|
CMOS-310/CMOS-210
Connect the camera to the camera connection cord.
Camera's cord length: 1.5 m (4.92 feet),
Power cord: 7.5 m (24.6 feet)
Fuse
Accessory power (ACC)
GND cord (Black)
Connect to a metallic part of vehicle (a part of chassis connected to the
negative side of power supply).
GND
Connect to the rearview camera video input or to the external
video input of the video monitor.
Video cord
CAM+ (Green/red)
CAM- (Green/white)
Accessory cord (Red)
Connect to the ON-OFF switchable power supply.
Do not connect to a permanently ON power supply.
Power cord
Fuse (2A)