Ot-Bx88Vii Installation Manual; Key To Symbols; Safety Precautions - Epson OT-BX88VII Installationshandbuch

OT-BX88VII Installation Manual

Introduction
The OT-BX88VII is a power supply cover (PS-Cover) to be attached under the TM-
T88VII printer to hold the power unit. This manual describes the procedures and
precautions for installing and using the OT-BX88VII.
Before using the product, read this manual carefully so that you will use the product
properly. Keep this manual available for reference.
All the illustrations are at the beginning of this manual.

Key to Symbols

The symbols in this manual are identified by their level of importance, as defined
below. Read the following carefully before handling the product.
WARNING:
You must follow warnings carefully to avoid serious bodily injury.
CAUTION:
Cautions must be observed to avoid minor injury to yourself, damage to your
equipment, or loss of data.
Note:
Notes have important information and useful tips on the operation of your equipment.

Safety Precautions

WARNING:
Use this product only for the TM-T88VII. Do not use for other products or other purposes.
Doing so may cause equipment damage and burning.
Use only the PS-190 as the power unit with this product. Be sure to read the "Usage
Precautions for the PS-190 Power Unit" for usage of the PS-190 to use it safely.
Do not allow foreign matter to fall into the equipment. Penetration by foreign objects may
lead to fire.
If water or other liquid spills into this equipment, unplug the AC cable immediately, and then
contact your dealer or a Seiko Epson service center for advice. Continued usage may lead to
fire.
CAUTION:
Do not connect cables in ways other than those mentioned in this manual. Different
connections may cause equipment damage and burning.
OT-BX88VII Installation Manual 1
English
English