IKEA FRYSA Handbuch Seite 16

ENGLISH
Problem
The compressor does not
start immediately after
pressing the Fast Freezing,
or after changing the tem-
perature.
Water flows on the floor.
Temperature cannot be set.
DEMO appears on the dis-
play.
The temperature in the ap-
pliance is too low/too high.
If your appliance still is not
working properly after making
the above checks, contact the
After Sales Service. You can find
the list at the end of this manual.
Possible cause
This is normal, no error has
occurred.
The melting water outlet is
not connected to the evap-
orative tray above the
compressor.
The Fast Freezing function
is switched on.
The appliance is in demon-
stration mode.
The temperature regulator
is not set correctly.
The food products' tem-
perature is too high.
The door has been
opened often.
The Fast Freezing function
is switched on.
There is no cold air circula-
tion in the appliance.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
3. If necessary, replace the defective door
The compressor starts after a
period of time.
Attach the melting water outlet
to the evaporative tray.
Switch off Fast Freezing man-
ually, or wait until the function
resets automatically to set the
temperature. Refer to "Fast
Freezing function".
Keep the OK pressed for ap-
proximately 10 seconds until a
long sound is heard and dis-
play shuts off for a short time.
Set a higher/lower tempera-
ture.
Let the food products temper-
ature decrease to room tem-
perature before storage.
Open the door only if necessa-
ry.
Refer to "Fast Freezing func-
tion".
Make sure that there is cold
air circulation in the appliance.
"Installation".
gaskets. Contact the After Sales Service.
16
Solution