Connecting The Power Cord (1) - Pioneer SPH-DA120 Installationsanleitung

Section
02 Connection

Connecting the power cord (1)

Note
Depending on the types of vehicles, the
function of *2 and *4 may be different. In this
case, be sure to connect *1 to *4 and *3 to *2
as shown in the figure.
ISO connector
Note
In some vehicles, the ISO connector may be divided
into two. In this case, be sure to connect to both
connectors.
8
Engb
*2 *1
*4 *3
Yellow (*2)
Yellow (*1)
Back-up
To terminal supplied with
(or accessory)
power regardless of ignition
switch position.
Red (*3)
Red (*4)
To electric terminal controlled by
Accessory
ignition switch (12 V DC) ON/OFF.
(or back-up)
Orange/white
To lighting switch terminal.
Black (earth)
To vehicle (metal) body.
Notes
· When a subwoofer (*5) is connected to this product
instead of a rear speaker, change the rear output
setting in the initial setting. (Refer to Operation
Manual.) The subwoofer output of this product is
monaural.
· When using a subwoofer of 70 W (2 Ω), be sure to
connect with violet and violet/black leads of this
product. Do not connect anything with green and
green/black leads.
Connect leads of the
same colour to each other.
Speaker leads
Front left 
White:
White/black: Front left 
Front right 
Grey:
Front right 
Grey/black:
Rear left or Subwoofer (*5)
Green:
Green/black: Rear left or Subwoofer (*5)
Rear right or Subwoofer (*5)
Violet:
Violet/black: Rear right or Subwoofer (*5)