Installing This Product; Installation Notes; Parts Supplied - Pioneer SPH-DA120 Installationsanleitung

Section
03 Installation

Installing this product

Installation notes

! Do not install this product in places subject
to high temperatures or humidity, such as:
— Places close to a heater, vent or air con-
ditioner.
— Places exposed to direct sunlight, such
as on top of the dashboard.
— Places that may be exposed to rain,
such as close to the door or on the vehi-
cle's floor.
! Install this product in an area strong en-
ough to bear its weight. Choose a position
where this product can be firmly installed,
and install it securely. If this product is not
securely installed, the current location of
the vehicle cannot be displayed correctly.
! Install this product horizontally on a sur-
face within 0 to 30 degrees tolerance (with-
in 5 degrees to the left or right). Improper
installation of the unit with the surface
tilted more than these tolerances increases
the potential for errors in the vehicle's loca-
tion display, and might otherwise cause re-
duced display performance.
30°
22
Engb
5° 5°
! When installing, to ensure proper heat dis-
persal when using this unit, make sure you
leave ample space behind the rear panel
and wrap any loose cables so they are not
blocking the vents.
Leave ample
5 cm
space
5 cm
! The cords must not cover the area shown
in the figure below. This is necessary to
allow the amps to dissipate heat.
Do not cover this area.

Parts supplied

Parts marked (*) are pre-installed.
This product
Truss head screw
(5 mm × 8 mm)
(6 pcs.)
Holder*
Flush surface screw
(5 mm × 9 mm)
(6 pcs.)