Herunterladen Inhalt Inhalt Diese Seite drucken

Connecting The Power Cord (2) - Pioneer SPH-DA120 Installationsanleitung

Smartphone-receiver
Vorschau ausblenden Andere Handbücher für SPH-DA120:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 122
Section
02
Connection

Connecting the power cord (2)

Light green (HANDBRAKE)
Used to detect the ON/OFF status of
the handbrake. This lead must be
connected to the power supply side of
the handbrake switch.
If this connection is made incorrectly
or omitted, certain functions of this
product will be unusable.
Note
The position of the handbrake switch
vary depending on the vehicle model.
For details, consult your authorised
Pioneer dealer or an installation
professional.
WARNING
LIGHT GREEN LEAD AT POWER CONNECTOR IS
DESIGNED TO DETECT PARKED STATUS AND MUST
BE CONNECTED TO THE POWER SUPPLY SIDE OF THE
HANDBRAKE SWITCH. IMPROPER CONNECTION OR
USE OF THIS LEAD MAY VIOLATE APPLICABLE LAW
AND MAY RESULT IN SERIOUS INJURY OR DAMAGE.
10
Engb
Connection method
Clamp the lead of the power supply
side of the handbrake switch.
Clamp firmly with needle-nosed
pliers.
This product
Violet/white (REVERSE-GEAR SIGNAL INPUT)
This is connected so that this product can detect
whether the vehicle is moving forwards or backwards.
Connect the violet/white lead to the lead whose voltage
changes when the reverse gear is engaged. Unless
connected, the sensor may not detect your vehicle
travelling forward/backward properly, and thus the
position of your vehicle detected by the sensor may be
misaligned from the actual position.
Note
When you use a rear view camera, please make
sure to connect this lead. Otherwise you cannot
switch to the rear view camera picture.
Power supply side
Earth side
Power supply
Power cord
Handbrake switch

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis