Understanding Built-In Cd Player Error Messages (Only Avh-P6400Cd); Using The Display Correctly; Handling The Display - Pioneer AVH-P6400CD Bedienungsanleitung

Additional Information
Understanding built-in CD player
error messages (Only AVH-
P6400CD)
When problems occur during CD play an error
message may appear on the display. If an error
message appears on the display refer to the
table below to see what the problem is and the
suggested method of correcting the problem. If
the error cannot be corrected, contact your
dealer or your nearest Pioneer Service Center.
Message Cause
ERROR-11, 12, Dirty disc
17, 30
ERROR-11, 12, Scratched disc
17, 30
ERROR-22, 23 The CD format
cannot be
played back.
ERROR-10, 11, Electrical or
12, 17, 30, A0 mechanical
ERROR-44 All tracks are
skip tracks

Using the Display Correctly

• If moisture or foreign matter should get
inside the product, turn OFF the power imme-
diately and consult your dealer or the nearest
authorized PIONEER Service Station. Using
the product in this condition may result in a
fire or electric shock, or other failure.
Action
• If you notice smoke, a strange noise or
Clean disc.
smell, or any other abnormal signs from the
display, turn OFF the power immediately and
Replace disc.
consult your dealer or the nearest authorized
PIONEER Service Station. Using the product
in this condition may result in failure of the
Replace disc.
system.
• Do not remove the rear cover of the display,
Turn the ignition
as there are high-voltage components inside
ON and OFF, or
which may cause an electric shock. Be sure to
switch to a
consult your dealer or the nearest authorized
different source,
PIONEER Service Station for internal inspec-
then back to the
tion, adjustments or repairs.
CD player.
Replace disc.

Handling the Display

• When the display is subjected to direct sun-
light for a long period of time, it will become
very hot resulting in possible damage to the
LCD screen. When not using this product, close
the display and avoid exposing it to direct sun-
light as much as possible.
• The display should be used within the temper-
ature ranges shown below.
Operating temperature range: –10 to +50 °C
Storage temperature range: –20 to +80 °C
At temperatures higher or lower than the oper-
ating temperature range the display may not
operate normally.
• The LCD screen of this product is exposed in
order to increase its visibility within the vehicle.
CAUTION
Section
15
71
En