Initial Settings; Adjusting Initial Settings; Setting The Fm Tuning Step; Setting The Dab Priority Function - Pioneer AVH-P6400CD Bedienungsanleitung

Initial Settings

Adjusting initial settings

1
Initial settings lets you perform initial set up of
different settings for this unit.
1
display
FUNCTION
Shows the function status.
You cannot select AUDIO MENU from the OFF
SOURCE MENU.
1 Press and hold until the unit turns
SOURCE
off.
2 Press and the OFF SOURCE
A.MENU
MENU is displayed.
3 Press 5 or ∞ to select
.
A.MENU
(FM tuning step)
FM STEP
(Priority function)
DAB PRIORITY
(Auto PI seek)
RDS AUTO PI
(Warning tone)
DETACH WARNING
(Auxiliary)
AUX
(Illumination color)
ILLUMINATION
(Rear output and subwoofer)
REAR SP
(Telephone muting)
TEL MUTE/ATT
You can operate a desired function. For details,
refer to the pages for each of the functions.
Use the following instructions to operate each
particular setting.
• To cancel initial settings, press
on the remote control.
WIDE
, and press
INIT
or
BAND/ESC

Setting the FM tuning step

Normally the FM tuning step employed by seek
tuning is 50 kHz. When AF or TA is on the tuning
step automatically changes to 100 kHz. It may
be preferable to set the tuning step to 50 kHz
when AF is on.
1 Press 5 or ∞ to select
INIT MENU, and press
FM STEP adjustment indications are displayed.
2 Select the FM tuning step with 2/3.
Pressing 2/3 will switch the FM tuning step
between 50 kHz and 100 kHz while AF or TA is
on. The selected FM tuning step will appear in
the display.
Note
• The tuning step remains at 50 kHz during
manual tuning.
Setting the DAB Priority
Function
When a hide-away DAB tuner (GEX-P700DAB) is
connected, you can set the product in this mode
so that the interruption of traffic information
from the hide-away DAB tuner takes
precedence over this product's RDS traffic
announcement function.
from the
FM STEP
.
A.MENU
En
Section
13
63