Using The High Pass Filter; Adjusting Source Levels - Pioneer AVH-P6400CD Bedienungsanleitung

Section
Audio Adjustments
12

Using the high pass filter

When you do not want low sounds from the
subwoofer output frequency range to play from
the front or rear speakers, switch the HPF (high
pass filter) on. Only frequencies higher than
those in the selected range are output from the
front and rear speakers.
1 Press 5 or ∞ to select
MENU, and press
HPF adjustment indications are displayed.
2 Press 5 to turn high pass filter on.
appears in the display. High pass filter
HPF:ON
is now on.
• To turn high pass filter off, press ∞.
3 Press 2 or 3 to select a high pass filter
range.
Press 2 and
FREQUENCY:50 Hz
Press 3 and
80 Hz
frequencies higher than those in the selected
range are output from the front or rear speak-
ers.
Note
• If you switch the
tion is automatically switched off. By switch-
ing the function on after selecting the
HPF
mode, you can combine
SFEQ
with function.
SFEQ
62
En
from the AUDIO
HPF
.
A.MENU
is displayed.
, is displayed. Only
125 Hz
mode, the func-
SFEQ HPF
function
HPF

Adjusting source levels

SLA (Source level adjustment) lets you adjust
the volume level of each source to prevent radi-
cal changes in volume when switching between
sources.
• Settings are based on the volume level of the
FM tuner, which remains unchanged.
1 Compare the FM tuner volume level with
the level of the source you wish to adjust.
2 Press 5 or ∞ to select
MENU, and press
A.MENU
SLA adjustment indications are displayed.
3 Press 5 or ∞ to adjust the source volume.
Each press of 5 or ∞ increases or decreases
the source volume.
• –
LEVEL:+4 LEVEL: –4
source volume is increased or decreased.
Notes
• Since the FM tuner volume is the control, it is
not possible to apply source level adjustments
to the FM tuner.
• The MW/LW tuner volume level can also be
adjusted with source level adjustments.
• The built-in CD and the multi-CD players are
both set to the same source level adjustment
volume automatically when using the AVH-
P6400CD.
• External unit 1 and External unit 2 are set to
the same volume adjustment setting automat-
ically.
from the AUDIO
SLA
.
is displayed as the