Connecting "Reverse-Gear Signal Input" Lead - Pioneer AVD-W6210 Anleitung

Connecting the System

Connecting "REVERSE-GEAR SIGNAL INPUT" Lead

When using this product with a back-up camera, automatic switching to AV IN2 video
when the gear shift is moved to the REVERSE (R) position is possible.
Connect the back-up camera to the AV IN2 input. (Refer to page 26.)
Power cable
(Refer to page 25.)
Violet/White
Of the two lead wires connected to the back lamp,
connect the one in which the voltage changes when
the gear shift is in the REVERSE (R) position.
CAUTION
This function is designed for use with a back-up camera only. Users may
connect the AV IN2 input with "REVERSE-GEAR SIGNAL INPUT" only
to a back-up camera. Users must not connect any other devices to the AV
IN2 input with "REVERSE-GEAR SIGNAL INPUT".
29
Hide-away Unit
Check the position of your
vehiche's reversing lamp (the one
that lights up when the gear shift is
in REVERSE [R]) and find the
reversing lamp lead in the trunk.
Note:
• When you have completed lead wire
connection, perform the appropriate
settings for the connection method.
(Refer to page 17.)
Connection method
Clamp the reversing lamp
lead.
Clamp firmly with needle-
nosed pliers.
Fuse resistor
Reversing
lamp lead