Connecting The Power Cable - Pioneer AVD-W6010 Anleitung

Connecting the System

Connecting the Power Cable

Power cable
Fuse resistor
Fuse holder (4 A)
Parking brake switch
Note:
• The position of the parking brake switch
depends on the vehicle model. For details,
consult the vehicle Owner's Manual or
dealer.
25
Hide-away Unit
RCA video output (yellow) (Refer to page 28.)
Fuse resistor
Power supply side
Ground side
Lightgreen/orange (Refer to page 29.)
Black (ground)
To vehicle (metal) body.
Red
To the electric terminal controlled by the ignition
switch (12 V DC) ON/OFF.
Do not connect this lead to power source terminals
to which power is continuously supplied. If the lead
is connected to such terminals, the battery may be
drained.
Yellow
To the terminal always supplied with power regard-
less of ignition switch position.
Light green
Used to detect the ON/OFF status of the parking
brake. This lead must be connected to the power
supply side of the parking brake switch.
Connecting method
Clamp the parking
brake switch power
supply side lead.
Clamp firmly
with needle-nosed
pliers.