Motor Unit With Drill Attachment Pkga1 - Parkside PKGA 20-Li C2 Originalbetriebsanleitung

Overview of the control display on
the charger (14):
Green LED lights up without battery in-
serted: Charger ready.
Green LED lights up: Battery such alleged
charged.
Red LED lights up: Battery charging.
Motor unit with drill
attachment PKGA1
Changing the tool
Secure the appliance against
switching on (see "Switch-
ing on/off"). If the appliance
is switched on accidentally,
there is a danger of injury.
1. Rotate the keyless chuck (1) towards
RELEASE
until the drill chuck aperture is
large enough to accommodate the tool.
2. Insert the tool as far as possible into
the keyless chuck (1).
3. Turn the keyless chuck towards
order to clamp the tool.
4. To remove the tool again, rotate the
keyless chuck (1) towards
the drill chuck aperture is large enough
to remove the tool.
Choice of gear
Stop appliance before
changing gear.
1. Wait for the appliance to come to a
standstill.
2 Slide the gear selector (3) into the re-
quired position:
1: 0-400 min
-1
2: 0-1350 min
GRIP
RELEASE
-1
Set the direction of rotation
The appliance's direction of rotation can
be changed with the rotational direction
switch.
The arrow on the direction switch indicates
the working direction.
1. Wait for the appliance to come to a
standstill.
2. Push the rotational direction speed
(7) into the desired position:
To drill and screw in screws: Press the
direction switch with the arrow poin-
ting forwards
To unscrew screws: Press the direction
switch with the arrow pointing back-
wards
3. If you place the direction switch
(7) in the middle position, the device is
secured against being switched on.
The direction change may only be
actuated when at a standstill!
Torque adjustment
in
You can preselect the maximum torque.
The torque settings are labelled 1 - 19 +
until
1. Wait for the appliance to come to a
standstill.
2. Turn the torque adjusting ring (2) to
select the desired torque:
Screws:
Drilling:
3. Start with a lower torque step and
increase as required.
The direction change may only be
actuated when the appliance is at a
standstill!
GB
Steps 1 - 19
Step
MT
81