Switching On/Off; Checking The Battery; Charge Level; Recharging The Battery - Parkside PKGA 20-Li C2 Originalbetriebsanleitung

GB MT
Removing appliance attachment
1. Push the unlocking lever (5) into posi-
tion as far as the stop and then
hold it in this position.
2. Pull the unlocked appliance attachment
off (4/16/22/26).
Fitting appliance attachment
3. Push the appliance attachment
(4/16/22/26) along the guide rail
into the motor unit (6).
4. Allow the unlocking lever (5) to slide
back into position
5. Check that the appliance attachment is
secure by pulling on it.
Inserting/removing
the battery
1. To remove the battery (9) from the de-
vice, press both release buttons (9b) on
the battery and pull the battery out.
2. To insert the battery (9), push the bat-
tery along the guide rail into the de-
vice. You will hear it click into place.
Only insert the rechargeable
battery once the device is
completely assembled. Risk
of injury!

Switching on/off

1. Switching on: Press the on/off switch
(10).
By using the on/off switch (10) you
can progressively control the speed.
Gentle pressure: low speed
Increase pressure: higher speed.
2. Switching off: Release the on/off
switch (10).
If you place the direction switch
(7) in the middle position, the device is
secured against being switched on.
80
.

Checking the battery

charge level
The battery's (9) charge level is indicated
by the charge state indicator (9a).
• The charge level of the battery is
indicated by illumination of the corre-
sponding LED lights while the device is
in operation. Press and hold the power
button to view.
red-yellow-green => Battery fully charged
red and yellow => Battery half charged
red
=> Battery needs
Charge the battery (9) when only
the red LED on the level indicator is
illuminated.

Recharging the battery

Allow a hot battery to cool before
charging.
Only charge the battery (9) when
the red LED on the charge status
indicator (9a) is on.
1. Remove the battery (9) from the appli-
ance, as necessary (see „Removing/
inserting the battery").
2. Insert the battery (9) in the charging
compartment of the battery charger
(14).
3. Plug the battery charger (14) into a
mains outlet.
4. When the battery is fully recharged un-
plug the battery charger (14) from the
mains.
5. Remove the battery (9) from the charg-
er (14).
to be charged