Parkside PKGA 20-Li C2 Originalbetriebsanleitung Seite 73

Cutting capacity
Wood .................................... 100 mm
Metal ...................................... 50 mm
Weight ......................................1.44 kg
Sound pressure level
(L ) ................... 89.3 dB(A), K
pA
Sound power level
(L ) ............... 100.3 dB(A), K
WA
Vibration (a ), Sawing
h
boards ..........12.395 m/s
wood beams .. 12.392 m/s
Motor unit with multifunction tool ... PKGA4
Oscillation rate (n
0
Oscillation angle ..............................3.0°
Weight ...........................................1 kg
Sound pressure level
(L ) ................... 84.8 dB(A), K
pA
Sound power level
(L ) ................. 95.8 dB(A), K
WA
Vibration (a ) ......4.229m/s
h
Attention! An up-to-date list
of battery compatibility can
be found at:
www.lidl.de/akku
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to com-
pare one power tool to another.
The stated vibration emission value may
also be used for a preliminary exposure
assessment.
Warning: The vibration emission
value may differ during actual use
of the power tool from the stated
value depending on the manner in
which the power tool is used.
Try to keep the exposure to vibra-
tions as low as possible. Examples
of measures to reduce vibration
exposure are the wearing of gloves
= 5 dB
pA
= 5 dB
WA
2 ; K=1.5 m/s
; K=1.5 m/s
2
) ............0-20000 min
= 3 dB
pA
= 3 dB
WA
, K= 1.5 m/s
2
when using the tool (except: operat-
ing mode drilling) and limiting the
working hours. For this purpose all
parts of the operating cycle have to
be considered (for example, times
when the electric tool is switched
off and times when it is switched on
but running without any load).
Notes on Safety
2
2
This section details the basic safety instruc-
tions for working with the appliance.
-1
Symbols
Symbols in the manual
Warning symbols with in-
formation on damage and
injury prevention.
2
Hazard symbol with infor-
mation on the prevention of
personal injury caused by
electric shock.
Instruction symbols with information
on preventing damage.
Wear safety gloves.
Wear ear protection.
Wear a protective mask.
Help symbols with information on
improving tool handling.
Symbols on the Equipment
Read through the instruction manual
carefully.
GB MT
73