Assembly - Parkside PNTS 1400 B1 Originalbetriebsanleitung

edges, by jamming, or by pulling on
the cable.
• Before each use, check the power sup-
ply lead and the extension cable for
damage and ageing. Do not use the
equipment if the cable is damaged or
worn. Danger of electric shock hazard.
• If the power cable for this equipment is
damaged, it must be replaced by the
manufacturer, a customer service agent
of the same or a similarly qualified per-
son in order to prevent hazards.
• Switch the machine off and pull the
plug under the following circumstances:
- when you are not using the device,
- transporting it or leaving it unat-
tended;
- when you are checking the device,
cleaning it or removing blockages;
- when you are carrying out cleaning
or maintenance work or replacing
accessories;
- when the power or extension cable
is damaged; after contact with for-
eign bodies or in case of abnormal
vibration.
• Only use replacement parts and acces-
sories delivered and recommended by
our Service Centre (see page 12). The
use of parts by other manufacturers im-
mediately renders the guarantee void.
• Do not use the cable to pull the plug
out of the socket. Protect the cable from
heat, oil, and sharp edges.
• Make sure that the mains voltage cor-
responds with the information on the
rating plate.
• Only plug the appliance into a socket
which is safeguarded by at least 16 A.
• The device must only be connected to
a mains socket via a residual-current
circuit breaker (RCD) with a rated leak-
age current of not more than 30 mA.
The.following.states.how.damage.
to.the.appliance.and.possible.in-
jury.to.people.can.be.avoided:
• Ensure that the machine is correctly
assembled and the filters are in the cor-
rect position.
• Do not use without the filter. This could
damage the machine.
• Only have repairs carried out at our
authorised customer service points.
• Observe the instructions for cleaning
and maintenance of the machine.
• Store the appliance in a dry place and
out of reach of children.

Assembly

Pull out the mains plug.
Danger of electric shock.
1. Plug the front steering castor (11) into
the slot on the front of the stainless
steel container (9). Fix the steering cas-
tor with 2 crosshead screws.
2. Plug the attachment ports (15) with the
rear steering castor (14) into the slot
on the rear of the stainless steel con-
tainer (9). Screw these in place with 2
crosshead screws.
3. Fit both wheels (12) and plastic wash-
ers (flat surface towards the equip-
ment). Fix each wheel with 1 cross-
head screw. Fit the hubcaps.
4. Fit the bow handle (1) onto the two
bow handle tie bars (2) and screw it in
place with 2 crosshead screws.
5. Fold down the bow handle (1) towards
the suction nozzle (8). Place the mo-
tor head (3) on the stainless steel
container (9). Close the stainless steel
container by folding up the bow han-
dle and fixing it with the locking levers
(the tension can be adjusted
GB
7