Maintenance And Cleaning; Cleaning - Parkside PKSA 20-Li B2 Originalbetriebsanleitung

GB IE
4. Felling back cut (B):
Make the back cut from the other
side of the log, where you stand
to the left of the log and saw with
the chainsaw pulling. The back
cut must run horizontally 5 cm
above the horizontal notched cut.
The back cut should be so deep
that the separation distance be-
tween the back cut and the notch
cutting line is at least 1/10 of
the trunk diameter. The part of
the stem not sawn through is
called a stay (felling gib). The
stay prevents the tree from turn-
ing and falling in the wrong di-
rection. Do not saw through the
stay.
5. As you approach the felling cut
on the stay the tree should start
falling. If it becomes apparent
that the tree may not fall in the
required direction or is lean-
ing back, and the saw chain is
jamming, stop felling and use
wedges made of wood, plastic
or aluminium to open the cut
and to tilt the tree in the required
felling line.
6. If the trunk diameter is larger
than the length of the chain bar,
make two cuts.
For safety reasons, we ad-
vise inexperienced users not
to fell any logs with a rail
length which is smaller than
the trunk diameter.
7. After carrying out of the back
cut, the tree falls by itself or with
the aid of the felling wedge or
crowbar.
50
As soon as the tree begins
to fall, pull out the saw from
the section, stop the motor,
place the chainsaw down
and leave the workplace us-
ing the withdrawal path.
Pay attention to falling
branches and do not stumble.
Maintenance and

cleaning

Maintenance and cleaning

work must always be carried
out with the motor switched
off and the batteries re-
moved. Danger of injury!
Leave any maintenance and
servicing work not covered
by this manual to our Ser-
vice-Center. Use only original
spare parts.
Allow the machine to cool
down before all maintenance
and cleaning works. Danger
of burn injuries!
Use cut-protection gloves
when handling the chain or
the chain bar. Risk of cuts!
Switch off the device and remove
the battery before carrying out any
maintenance work.
Cleaning
• Clean the machine thoroughly after
every use. In this way, you extend the
life of the machine and avoid acci-
dents.
• Keep the gripping handles free of pet-
rol, oil or grease. Clean the gripping
handles, where appropriate, with a