Conrad 40 55 86 Bedienungsanleitung Seite 2

O P E R A T I N G I N S T R U C T I O N S
Mobile Storage Adapter
for iOS devices
Item no. 40 55 86
Intended Use
The product is used as WLAN Hotspot, as mobile storage solution via USB stick or SD memory card for iOS
devices with their own App (direct access to USB stick or SD memory card is also possible from notebook
or Android).
The inbuilt rechargeable battery enables an independent operation and use. For example, recharging takes
place via the USB port of a computer or a USB hub with individual power supply or via a power supply with
USB port (e.g. power supply of an iPad).
The safety instructions must be observed at all times!
Any use other than that described above could lead to damage to this product and involves the risk of short
circuits, fi re, electric shock, etc. No part of the product may be modifi ed or converted!
This product complies with the applicable national and European requirements. All names of companies and
products are the trademarks of the respective owners. All rights reserved.
Package Contents
• Mobile Storage Adapter
• USB cable
• Quick guide
• Manufacturer's operation instructions (in English)
Safety Instructions
The warranty will be void in the event of damage caused by failure to observe these safety
instructions! We do not assume any liability for any resulting damage!
We shall not accept liability for damage to property or personal injury caused by incorrect
handling or non-compliance with the safety instructions! In such cases, the warranty will
be null and void.
• The unauthorised conversion and/or modifi cation of the product is not permitted for safety and
approval reasons (CE). Never dismantle the product.
• The product is not a toy and should be kept out of the reach of children.
• The product is only intended for use in dry, enclosed spaces, it must not get damp or wet.
Protect the product against cold, heat, dust, dirt and direct sunlight.
• Do not leave the packaging material carelessly lying around, since it could become a danger-
ous plaything for children.
• Handle the product with care; it can be damaged by impacts, blows, or accidental falls, even
from a low height.
Connection and Getting Started
Charging the accumulator
• First, charge the accumulator of the mobile storage adapter. For this purpose, connect the adapter to a
USB port of a computer, a USB hub with individual power supply or directly to a power supply with USB
port (e.g. the power supply of the iPad) using the USB cable provided.
• Charging a spent rechargeable battery takes about 2.5 hours. Of course, you can use the product during
the charging process. This may increase the charging time.
Use as mobile storage with iOS devices
• Switch the mobile storage adapter on (green surface visible at the inside of the sliding switch). The start of
the WLAN hotspot in the mobile storage adapter takes at least 35 seconds.
• Start e.g. your iPad and perform a search for available WLAN networks.
You should now fi nd the WLAN of the WLAN hotspot. The SSID is "Wi-Reader_xxxxxx" (the letters "x" at
the end stand for a random serial number, see e.g. imprint on the mobile storage adapter).
• Connect the WLAN e.g. of the iPad to the mobile storage adapter.
There is no encryption in the default setting of the mobile storage adapter; the access to the internet is
possible immediately.
This presetting has been chosen intentionally so that you are able to access the internet directly
without any confi guration work.
Of course you can set an encryption (e.g. WPA2) in the set-up menu of the mobile storage
adapter.
• Plug either a USB memory stick or an SD memory card (SD/SDHC/SDXC) into the mobile storage adapt-
er. It is not possible to use both memory types at the same time.
• Download the App "Wi-Reader" from the App Store (the App is free of charge).
• Start the downloaded App. This App allows you to view e.g. images from the USB stick or the SD memory
card, download images onto the iOS device or save images from the iOS device onto the USB stick or the
SD memory card.
Example: With the App you can e. g. copy images from an iPad onto an SD memory card in order to have
those images printed via one of the photo printers available in many places.
Operating the product as WLAN Hotspot
www.conrad.com
• Connect the RJ45 socket of the mobile storage adapter to the network, e.g. to the internet connection in a
hotel, using a 1:1 connected cable.
Version 03/13
• Switch the mobile storage adapter on (green surface visible at the inside of the sliding switch). The start of
the WLAN hotspot in the mobile storage adapter takes at least 35 seconds.
• Start e.g. your iPad and perform a search for available WLAN networks.
You should now fi nd the WLAN of the WLAN hotspot. The SSID is "Wi-Reader_xxxxxx" (the letters "x" at
the end stand for a random serial number, see e.g. imprint on the mobile storage adapter).
• Connect the WLAN e.g. of the iPad to the mobile storage adapter.
There is no encryption in the default setting of the mobile storage adapter; the access to the internet is
possible immediately.
Tips and Notes
• Behind the small opening next to the mini USB socket, there is an inbuilt reset push-button.
In order to reset the mobile storage adapter, the latter has to be switched on. Press and hold the push-
button for approximately 3 seconds (e.g. with a paper clip). All settings will be lost and the mobile storage
adapter will be in its original delivery state again.
The mobile storage adapter performs a restart; this takes at least 35 seconds; afterwards the device is
operational.
• When the mobile storage adapter is operated via rechargeable battery, switch it off if you don't need the
product in order to save power.
• The mobile storage adapter has its own webserver for the confi guration.
For this purpose, the mobile storage adapter has to be switched on and operational and e.g. an iPad or an-
other device has to be connected to the WLAN of the mobile storage adapter (SSID "Wi-Reader_xxxxxx")
Enter the following IP address: http://10.10.1.1 into the address line of your browser
The settings menu of the mobile storage adapter appears above the fi eld "settings" at the top right. Here
you can enable an encryption and also confi gure the WLAN Hotspot as router.
• Via the IP address http://10.10.1.1 and by clicking on the directory "Wi Reader" that appears on the left
edge of the screen, you are also able to access the USB stick (or the SD memory card) directly from other
devices (e.g. Android telephone/ tablet or notebook). Hereby, it is important that the devices are connected
to the WLAN of the mobile storage adapter (SSID ex works "Wi-Reader_xxxxxx"), so that they are in the
same network and receive a corresponding IP address from the mobile storage adapter.
Maintenance and Care
Prior to cleaning the product, switch the product off.
Use a clean, dry, soft cloth for cleaning. Do not use aggressive cleaning agents, as these can cause discol-
ouration. Do not press too strongly on the surface when cleaning, to prevent scratch marks.
Dust can easily be removed using a clean, long-haired brush and a vacuum cleaner.
Disposal
Declaration of Conformity (DOC)
We, Conrad Electronic, Klaus-Conrad-Straße 1, D-92240 Hirschau, hereby declare that this product con-
forms to the fundamental requirements and the other relevant regulations of the directive 1999/5/EC.
Technical Data
Operating voltage ............................5 V/DC
Power consumption .........................max. 500 mA
Integrated rechargeable battery ......LiPo, 3.7 V, 1100 mAh
WLAN ..............................................802.11b/g/n
SSID ................................................"Wi-Reader_xxxxxx" (the last digits are the serial number)
LAN-Port ..........................................10/100MBit, for connection to the local LAN
Required iOS version ......................from 5.0
Dimensions ......................................60 x 50 x 25 mm
Weight .............................................55 g
Naturally, this network has to be unlocked for you. In case of doubt, ask e.g. at the reception.
This presetting has been chosen intentionally so that you are able to access the internet directly
without any confi guration work.
Of course you can set an encryption (e.g. WPA2) in the set-up menu of the mobile storage
adapter.
Please consult the provided manufacturer's extensive (English) instruction manual.
Dispose of an unserviceable product in accordance with the relevant statutory regulations.
The Declaration of Conformity for this product can be found at www.conrad.com.
These operating instructions are a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1,
D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfi lming,
or the capture in electronic data processing systems require the prior written approval by the editor.
Reprinting, also in part, is prohibited.
These operating instructions represent the technical status at the time of printing. Changes in
technology and equipment reserved.
© Copyright 2013 by Conrad Electronic SE.