Kenwood VC2783 Serie Bedienungsanleitung Seite 8

EN
DO NOT THROW AWAY THESE INSTRUCTIONS
DESCRIPTION OF THE APPLIANCE (FIG.1)
1 Bag full indicator
2 On/Off switch
3 Suction power regulation
4 Cord re-wind switch
5 Carry handle
6 Dust bag compartment
7 Dust bag compartment release switch
8 Flexible hose
9 Narrow suction nozzle with brush
10 Telescopic tube
11 Slider device
12 Hand grip
13 Suction control
14 Floor brush
15 Hard floors/carpet selector
ASSEMBLING THE VACUUM CLEANER
Insert the nozzle connector into the nozzle compartment and turn it clockwise until it locks into
place (FIG. 2). To remove the nozzle connector, turn it anticlockwise and remove it from its seat.
CAUTION: Before fitting or removing attachments, always make sure that the vacuum cleaner has
been unplugged from the mains power.
ATTACHMENTS
Telescopic tube (10)
Insert the telescopic tube into the handle. Push the slider device forwards and pull the bottom sec-
tion of the tube out to the required length (FIG. 3). Then simply release the slider and the device will
return to its original position. Fit the required attachment to the telescopic tube.
Floor brush (14)
This is used for cleaning large areas and to reach any corner with ease.
- Cleans rugs and carpets without the need for a brush attachment. Press the tip switch marked
with the carpet symbol
- Smooth flooring, such as PVC, parquet or tiles, is best cleaned and cared for if the brush attach-
ment is used. Press the tip switch with the smooth floor symbol
come out.
Narrow suction nozzle with brush (9)
This suction device is ideal for cleaning between the folds on fabrics, joints, corners or niches that
are impossible to reach using the floor cleaning device. This attachment can also be fitted directly
to the handle (12).
and this will raise the brush.
- 6 -
and the brush will