Electrolux WELL WA51-303-Serie Bedienungsanleitung Seite 9

UNBOXING & SETUP – picture pages 6-7
Please be careful while unboxing the air purifier. The unit has several detachable
components which may have come loose in transport, so open the box with care and
while placed on a large flat surface OR the floor.
1. Gently remove the unit (e.g. with top handle when available) and the ancillary
components from the main box. Remove the plastic packaging and discard as per
safety and local recycling instructions.
2. If wall mounting:
a. Please review safety instructions under the GENERAL SAFETY section
before proceeding.
b. Identify a spot on the wall where you would like to mount the unit. The
spot should be at least 20 cm below eye level when standing fully upright
(even lower is ideal & recommended), for optimal viewing as well as
cleanability under the unit. Also ensure that nearest power socket is max
1,5 mts away and that there is a clearing of at least 20 cm between right
side (sensor window) of the unit and other nearby surface.
c. Gently place the provided hook flat against the surface of the wall and
with a pencil mark the two spots where screws are to be drilled. The hook
should be placed such that the protruding tip (without the holes) is on
the top (refer to picture #2).
d. Depending on the wall, please use appropriate drill to make two holes
into the wall at the identified marks; and insert any plugs as needed.
e. Depending on the wall, please use appropriate screws for following step.
Place the hook flat against the surface of the wall, so that the holes are
concentric and the hook sits parallel to the floor without any inclination,
and then tighten the screws till the hook is securely in place and does not
move if tugged.
f. Lift the unit and place it onto the hook such that the top of the hook
securely fits into the inbuilt grip at the back of the unit.
g. Gently adjust the unit to remove any inclinations, just like a painting.
Ensure that the unit sits flat up against the wall.
h. When dismounting the unit, remember to disconnect the power cord
from the wall socket first.
3. If placing it on the floor:
a. Take the cylindrical feet and screw them into the unit by rotating
clockwise till you hear a click (or get some resistance).
Classified as Internal