Electrolux WELL WA51-303-Serie Bedienungsanleitung Seite 17

FEET CUSTOMIZATION
The thermoplastic elastomer (TPE) feet are attached to the unit by way of inbuilt
screws. The feet – like the top handle – are detachable. Follow the steps below to
attach or replace an existing set of feet.
44. Place the unit flat on its back, so the front panel faces the ceiling. Unscrew the
existing feet, if any, by twisting counterclockwise.
45. Remove any protective plastic covering the new set of feet.
46. Gently nudge the inbuilt screw of the new feet into the cavity at the bottom of
the unit and secure them by twisting clockwise till you meet some resistance.
47. Test out the stability of the feet by placing the unit back upright and lifting it
about 5-6 cm above the ground and giving it a gentle shake.
ERRORS & TROUBLESHOOTING
The table below is only a limited list. For the latest and complete section on
troubleshooting, FAQ and error guide please refer to the corresponding section on
our website or the Wellbeing App.
# ISSUE
1 The air purifier's
alert icon is lit
Classified as Internal
TROUBLESHOOTING
If you have just bought the unit OR inserted new
filter(s), please ensure that the filter(s) are
positioned in the correct way for the RFID tags to be
read by the sensor (refer to point 6 within
ONBOARDING & SETUP section above).
Generally, the unit comes with a variety of
sophisticated sensors,
electrical components and if one of these is
malfunctioning, you will see the alert icon on the
product UI light up. For more details on steps to
resolve, please head over to the Wellbeing App and
check for details whenever you see this icon lit.
electronics and other
NOTES
Please have at hand
the unit's PNC and
SERIAL number when
calling for support.