Electrolux WELL WA51-303-Serie Bedienungsanleitung Seite 10

b. Lift the unit and place it next to the power socket to be used.
c. Ensure a clearance of at least 30 cm between front (air inlet) and at least
20 cm between right side (sensor window) of the unit and other surfaces.
Also ensure ample free space above the top (air outlet grill), so the unit
can operate at its best in spreading pure air through the room.
d. When wall mounting, please remove the cylindrical feet from the base of
the unit for more efficient air distribution.
4. Remove the front panel by gently pulling it away from the unit with both hands.
5. Take out the mesh pre-filter, ultrafine particle filter and VOC carbon filter layers
and remove all plastic packaging. Discard as per safety and local recycling
instructions.
6. Place the filter layers back into the unit in the same order as originally found (i.e.
VOC carbon filter goes in first). While inserting, place take care to hold the filter
so that the RFID tag on the filter is located at the top-right – it should be near the
senor box hatch.
7. Attach the mesh pre-filter and the front panel back to the unit.
8. Plug the unit's power cord to the nearest power socket so that the POWER button
on the product UI gets illuminated.
9. For best results, operate the unit in an enclosed area with doors & windows
closed when feasible.
FIRST & ONGOING USE – picture pages 6-7
TURNING ON
10. Tap the POWER button
NOTE: At every new run, it will take about 10 seconds for the sensors to calibrate and analyze the air quality before
ramping up to the appropriate fan speed. During this time, the air quality indicator will pulsate slowly in white.
CHANGING MODES & FAN SPEEDS
11. Tap the MODE button
MANUAL
SMART: This is the default mode the unit will start in. In the SMART mode the
unit will utilize the sensor data as input to decide on the appropriate fan speed
Classified as Internal
once to turn ON the air purifier
once to toggle between the two modes: SMART and