Herunterladen Inhalt Inhalt Diese Seite drucken

Pioneer SGY-PM910H2 Benutzerhandbuch Seite 25

Pedaling monitor sensor
Vorschau ausblenden Andere Handbücher für SGY-PM910H2:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 34
6. Tap [Search].
The search for the sensor starts.
A [Searching. Please wait.] message
appears.
7. Check the information about
the sensor.
Information about the sensors appears
when the sensors are found.
Check the following items.
• [Device Number]
Make sure that the device number
is the same as the device number
of the transmitter.
• [Error Rate]
Make sure that "OK" is displayed.
Pairing with the Cyclocomputer
• The device numbers are printed on
the right junction box and on the side
of the left sensor. If the numbers that
are displayed on (Page 7)[Device
Number] are different from the
transmitter device numbers, specify
the device numbers to pair with the
sensor. Refer to the User's Guide
(For WEB) of the Cyclocomputer
SGX-CA500 regarding how to
specify a device number to pair a
sensor.
• If "Processing..." is displayed in the
[Error Rate] area, the information
from the sensor is not being received
correctly because transmission
conditions are bad. Make sure
that the sensor you are pairing is
activated, then bring the SGX-CA500
closer to the sensor and perform the
pairing operation again.
• Pairing with the sensor may not
be possible due to interference
in the same frequency band. If
"Processing..." is displayed even if
the SGX-CA500 is moved closer
to the sensor and paired with it, try
again someplace where there is no
interference from microwaves, radio
waves, or wireless equipment.
Pairing of the right transmitter is
completed. Pair the left transmitter in
the same way.
EN
25

Werbung

Inhaltsverzeichnis

Fehlerbehebung

loading

Diese Anleitung auch für:

Sgy-pm910hrSgy-pm910hl

Inhaltsverzeichnis