Switch To Single Power Meter Mode - Pioneer SGY-PM910H2 Benutzerhandbuch

Switch to single power meter mode

• If the actual sensor mode is pedaling monitor mode, switch it on SGX-CA500.
• The firmware version of SGX-CA500 needs to be 20150501.02.43 or higher. If it is of
a different version, update the firmware. Refer to the User's Guide (For WEB) of SGX-
CA500 regarding how to update.
http://pioneer-cyclesports.com/us-en/support/products/
The mode can be switched in two ways. Select according to the actual sensor mode.
[Method 1] Switch by pushing the
push switch in the right transmitter
• When using a Cyclocomputer from
another manufacturer, switch with
this method.
• When it is in the dual power meter
mode, if the left and right transmitters
are not started, the mode cannot be
switched to the single power meter
mode.
Rotate the crank set of the bicycle and
start the sensor. (Described on Page
16)
When it is in dual power meter mode,
if you push the push switch in the right
transmitter for more than 3 seconds,
the mode changes to single power
meter mode and the LEDs blink orange
for 10 seconds.
When the LEDs blink red, the left
transmitter may not have started. Start
it again.
When the sensor is in pealing monitor
mode, it does not change to the single
power meter mode, even on pushing
the the push switch. Switch using
method 2.
[Method 2] Switch the sensor mode
from SGX-CA500
If the mode is pedaling monitor
mode or dual power meter mode,
switch using the SGX-CA500. Do the
operation as described on Page 15,
and go to the mode switching screen.
Check the sensor you want to use,
then select single power and switch
the mode.
For how to pair with the cyclocomputer,
refer to Page 24. When the mode
is switched, the LEDs of the sensors
blink orange for 10 seconds.
EN
23