Pioneer SGY-PM910H Benutzerhandbuch Seite 17

■ Zero point calibration fails.
Cause
The crank is subjected to external
force or moving.
■ The Cyclocomputer display is not displaying correctly while I am riding.
Cause
Zero point calibration fails.
■ There is a rattling noise when I am riding.
Cause
Screws used to install the sensor
are loose.
■ The magnet is rubbing against the sensor or transmitter while I am riding.
Cause
Foreign objects are attached to
the magnet and rub against the
transmitter or the junction box.
Solution
Calibrate the sensor in still condition (see page 14).
Solution
Calibrate the sensor when the values in [Force Preview] are
more than ± 3 N (see page 14).
Solution
Retighten the screws.
Solution
Clean the transmitter, junction box, and magnet.
EN
Troubleshooting
17