Switching Modes - Pioneer SGY-PM910H Benutzerhandbuch

Switching Modes

EN
This section describes how to switch the sensor mode.
• Please do not push the push switch in the right transmitter while calibrating the sensor
or showing [Force Preview] with the Cyclocomputer SGX-CA500.
1.
Loosen the screws on the
right transmitter cover and
remove the cover.
• See page 7 to remove the right
transmitter cover.
2.
Start the sensors.
Rotate the bicycle's crank set more
than three rotations to start the left and
right transmitters.
10
3.
Check the sensor modes.
By pushing the push switch in the right
transmitter for less than 2 seconds,
the LEDs on the right transmitter blink
green. After then the LEDs on the left
and right transmitters light as follows
depending on the actual sensor mode.
•
Pedaling monitor mode:
The LEDs light green for 10 seconds.
•
Power meter mode:
The LEDs light orange for 10
seconds.
Push switch
LED
• If the pairing between the left and
right transmitters fails, the LEDs
blink red 5 times.