Basic Operations; Basic Receiver Operations - Yamaha pianoCraft DVD-E810 Bedienungsanleitung

Basic Receiver Operations

Follow the procedure below to select an input source and adjust the sound settings on the receiver.
PHONES
NATURAL SOUND STEREO RECEIVER RX-E810
DISPLAY MEMORY
TIMER
TIME ADJ
BASS
STANDBY/ON
PHONES
BASS
STANDBY/ON
STANDBY/ON
( )
1
5
A E
9
SET UP
TV VOL
DVD/CD
TAPE/MD
SUBTITLE ANGLE
1
Press STANDBY/ON to turn on the receiver.
If the DVD player is connected to the receiver with
the system control cable, the DVD player turns on
automatically. The front panel display of each
component lights up.
y
This system has the auto-standby function (see page 45) which
automatically set to the system to the standby mode if you do not
operate the system for 30 minutes while the receiver is set to the
DVD/CD input mode.
2
Press one of the input selection keys to
select the desired input source.
22
En
Basic Receiver Operations
PURE DIRECT
BALANCE
PURE DIRECT
AUTO/MAN'L PRESET/BAND PRESET/TUNING
VOLUME
TIMER HOUR MIN
INPUT
TREBLE BALANCE
L R
MIN MAX
TREBLE
POWER
TV
2 3 4
6 7 8
SCAN DIMMER
ENTER A E
0
TOP MENU
/RETURN
VOLUME
DISPLAY
VOLUME +/–
SLEEP
TUNER BAND
Input
AUX/TV DOCK
selection
ZOOM AUDIO
keys
3
Start playback on the selected source
component or select a broadcast station.
For information on the disc playback, see page 25, and
for information on tuning, see page 37.
4
Press VOLUME +/– to adjust the volume to
the desired output level.
5
Rotate BASS, TREBLE, or BALANCE on the
front panel of the receiver to adjust the
following settings.
BASS: Adjusts the low frequency response.
TREBLE: Adjusts the high frequency response.
BALANCE: Adjusts the volume level of each left
and right speaker channel.
Pure Direct mode
The Pure Direct mode shuts down the tone control
circuitry, allowing you to enjoy pure high-fidelity sounds
from analog sources.
Press PURE DIRECT on the front panel of the
receiver to turn on the Pure Direct mode.
PURE DIRECT lights up, and the front panel display
automatically dims.
Notes
• While the Pure Direct mode is turned on, neither BASS,
TREBLE, nor BALANCE are available.
• If you carry out any operation while the Pure Direct mode is
turned on, the front panel display lights up briefly to
acknowledge the command and dims again.
To turn off the Pure Direct mode
Press PURE DIRECT again so that PURE DIRECT turns
off and the front panel display lights up.
To use headphones
Connect the headphones to the PHONES jack. You can
listen to the sound to be output from the speakers through
the headphones.