General Power Tool Safety Warnings; Work Area Safety; Electrical Safety - Parkside PBH 1050 B2 Originalbetriebsanleitung

Total vibration value:
Total vibration values (vector total of three direc-
tions) determined in accordance with EN 60745:
Hammer drilling
in concrete: a = 8.527 m/s
h(HD)
Chiselling: a = 11.293 m/s
h(CHeq)
NOTE
► The vibration level specified in these instructions
has been measured in accordance with a
standardised measuring procedure and can
be used for equipment comparisons. The
specified vibration emission value can also
be used to make an initial exposure estimate.
WARNING!
► The vibration level will vary according to the
use of the power tool and may sometimes
be higher than the value specified in these
instructions.
Regular use of the power tool in this way may
cause the user to underestimate the vibration.
Try to keep the vibration loads as low as pos-
sible. Measures to reduce the vibration load
are, e.g. wearing gloves and limiting the work-
ing time. Wherein all states of operation must
be included (e.g. times when the power tool is
switched off and times where the power tool is
switched on but running without load).
PBH 1050 B2
2 , K = 1.5 m/s 2
2 , K = 1.5 m/s 2
General Power Tool
Safety Warnings
WARNING!
► Read all safety warnings and all instructions.
Failure to follow the warnings and instructions
may result in electric shock, fire and/or serious
injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-
operated (cordless) power tool.

1. Work area safety

a) Keep work area clean and well lit.
Cluttered or dark areas invite accidents.
b) Do not operate power tools in explosive atmos-
pheres, such as in the presence of flammable
liquids, gases or dust. Power tools create sparks
which may ignite the dust or fumes.
c) Keep children and bystanders away while
operating a power tool. Distractions can
cause you to lose control.

2. Electrical safety

a) Power tool plugs must match the outlet. Never
modify the plug in any way. Do not use any
adapter plugs with earthed (grounded)
power tools. Unmodified plugs and matching
outlets will reduce risk of electric shock.
b) Avoid body contact with earthed or grounded
surfaces, such as pipes, radiators, ranges and
refrigerators. There is an increased risk of electric
shock if your body is earthed or grounded.
GB 3 ■
│