Asus P Serie Installationshandbuch Seite 8

Installing the foot stand
1. Insert the foot stand hooks into
the holes on the chassis.
NOTE: To remove the foot stand, lift the lock, then slightly push the foot stand to the
direction of the rear panel until it disengages from the chassis.
Reinstalling the front panel cover
1. Insert the front panel
cover tabs to the holes
on the right side of the
chassis, then swing
the front panel cover to
the left.
2. Insert the front panel
cover hooks to the
chassis until the front
panel cover fits in
place.
Reinstalling the cover
1. Insert the cover to the chasis. Make sure the cover tabs fit the chasis rails.
2. Push the cover toward the front panel until it fits in place.
3. Secure the cover with two screws you removed earlier.
NOTE: Refer to the pictures in the section "Removing the cover" on page 3 in reverse
order.
NOTE: For P2 model, if your optical
drive tray fails to eject when you press
the eject button, attach the provided
stickers (0.5mm and 1.0mm) to the
location shown at the back of the front
panel cover. Make sure the sticker aligns
with the optical drive eject button.
8
2. Pull the foot stand to the direction
of the arrow until the lock snaps
in place.
1
Installation manual
2
R
Sticker