Maintenance Schedule; Maintenance - Husqvarna ER 105 Bedienungsanweisung

To connect the product to a power
source
WARNING: Use approved power outlets and
extension cables with approved plugs.
1. Connect the product to the power supply with a
cable of type HO7RN-F with one yellow and green
ground cable (A). Make sure there is no tension or
friction.
Note: ER 207B, ER 407B and ER 507B have a 0.6
m/1.9 ft connection cable connected to a plug. The
cable is of type A07RNF 3 x 2.5 mm
WARNING: Make sure that the
connection to the connection box pins
agrees with the "Electrical connection"
instructions on the label.
2. Make sure that the dimension of the connection
cable agrees with the value specified on the rating
plate. Keep the connection cable short. Long cables
can cause voltage drop.
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.

Maintenance schedule

Maintenance

Clean the product.
Lubricate the bearings.
1586 - 001 - 26.03.2021
A
2
.
Maintenance
Before use, each 10h
X
3. Put the washers in the correct positions. Tighten the
nuts (B) on the connection pins to the correct torque.
Tightening torque on page 19 .
Refer to
B
4. Connect the ground cable to the connector (C) in the
connection box with a corrosion resistant screw.
5. Install the cover of the connection box tightly.
Each 2 weeks, 75h
Bearing lubrication on page 19 .
Refer to
C
Each 4 weeks, 100h
11