Herunterladen Inhalt Inhalt Diese Seite drucken

Service; Safety Instructions For Drills - Parkside PSBM 750 B3 Originalbetriebsanleitung

Vorschau ausblenden Andere Handbücher für PSBM 750 B3:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

e) Maintain power tools and accessories. Check
for misalignment or binding of moving parts,
breakage of parts and any other condition
that may affect the power tool's operation. If
damaged, have the power tool repaired
before use. Many accidents are caused by
poorly maintained power tools.
f) Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting
edges are less likely to bind and are easier to
control.
g) Use the power tool, accessories and tool bits
etc. in accordance with these instructions,
taking into account the working conditions
and the work to be performed. Use of the
power tool for operations different from those
intended could result in a hazardous situation.
h) Keep handles and grasping surfaces dry,
clean and free from oil and grease. Slippery
handles and grasping surfaces do not allow for
safe handling and control of the tool in unex-
pected situations.

5. Service

a) Have your power tool serviced by a qualified
repair person using only identical replace-
ment parts. This will ensure that the safety of
the power tool is maintained.
PSBM 750 B3

Safety instructions for drills

Safety instructions for all work
Wear ear muffs when hammer-
drilling. Exposure to loud noise can
lead to hearing loss.
Use the additional handle. Loss of control can
lead to injuries.
Hold the power tool only by the insulated
handles when you are carrying out work
in which the accessory tool may come into
contact with concealed power cables or the
tool's own power cord. Contact with a live wire
may electrify exposed metal parts of the tool and
could give the operator an electric shock.
Wear a dust mask.
Safety information for using long drill bits
Do not use a higher rotational speed than
the maximum permissible speed. At higher
speeds, the drill bit can bend slightly if allowed
to turn freely without being in contact with the
workpiece and this can lead to injuries.
Always start drilling at a low speed and with
the drill bit in contact with the workpiece. At
higher speeds, the drill bit can bend slightly if
allowed to turn freely without being in contact
with the workpiece and this can lead to injuries.
Do not exert excessive pressure and only
along the length of the drill bit (no lateral
pressure). Drill bits can bend and break which
can lead to a loss of control and injuries.
GB │ IE │ NI │ CY
 5

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Ian 336948 2001

Inhaltsverzeichnis