Face Joints - Parkside PUD 30 A1 Bedienungsanleitung

Face joints

♦ Attach the adjustable stop to the underside of the product and
screw in the locking screw loosely (see Fig. D).
♦ Place the drill bush onto a dowel on wooden workpiece .
Push the adjustable stop against wooden workpiece , tighten the
locking screw and remove the product (see Fig. E). This determines
the correct spacing for the drill holes in wooden workpiece .
♦ Clamp both wooden workpieces flush together, e.g. on a work-
bench (see Fig. G).
♦ Leave the drilling depth as for wooden workpiece .
♦ Slide the product with the matching guide groove to the drill bush
over the dowel until it stops (see Fig. G).
♦ Insert the drill into the drill bush and drill a hole (see Fig. G).
♦ Fill the drill holes with wood glue.
♦ Join the two wooden workpieces.
PUD 30 A1
GB │ MT │
17 ■