Installation Of Clip-On Parts; Trouble Running; Disposing; Warranty - Märklin 74492 Bedienungsanleitung

7. Installation of clip-on parts

Replace the turnout lever (1) with the turnout motor detail
part (3) or the turnout cover (2).
!
After the turnout lever has been removed, the turnout can
only be set with the 72752 control box.

8. Trouble Running

If the turnout mechanism does not work, check the following:
• Is the switched mode power pack plugged into the wall
outlet and the Base Station? If not, plug it in.
• Are all of the connecting cables properly plugged into
their connections? If not, press on the plugs to make sure
they are all the way in the connections.
• Is a connecting cable damaged? Replace any damaged
cables.
All manuals and user guides at all-guides.com
• iIs the bar on the turnout mechanism correctly hung on the

9. Disposing:

10. Warranty

The warranty card included with this product specifies the
warranty conditions.
• Please contact your authorized Märklin dealer for repairs
turnout linkage? Check and correct if necessary.
Notes about environmental protection: Products
that are identified with a garbage container with
a line through it may not be disposed of at the
end of their useful life with the normal household
trash. They must be taken to a collection point
for recycling.
Disposing: www.maerklin.com/en/imprint.html
or contact:
Gebr. Märklin & Cie. GmbH
Reparaturservice
Stuttgarter Str. 55 - 57
73033 Göppingen
Germany
+49 7161 608 222
E-Mail: Service@maerklin.de
11