Specifications; When General-Purpose Applications Or Milling Machine Function Are Selected ( Is Set In The Model Type Selection Mode Of The Basic Settings) - Sony LH70-Serie Bedienungsanleitung

11. Specifications

Common Specifications
Model name
Function
Display
Connectable measuring
unit
Measuring unit input
resolution
Minimum display resolution
Input signal
Minimum input phase
difference
Quantization error
Alarm display
Preset
Reference point detection
Data storage
Linear error compensation
Sleep
Power supply
Power consumption
Operating temperature
range
Storage temperature range
Mass
When general-purpose applications or milling machine function are selected
( is set in the model type selection mode of the basic settings)
Model name
Function
Display axes
Multi datum point
Bolt hole circle
Simple R cutting
When lathe function is selected
(Select using the basic setting model type selection mode.)
Model name
Function
Display axes
Tool offset
Measuring unit input
addition
Display hold
LH70
LH70-1
7 digits and minus display, Color amber
GB-A, PL20B, DG-B (Necessary to use the conversion adaptor which
Standard: 0.1 um, 0.5 um, 1 um, 5 um, 10 um, 1 s, 10 s, 1 min, 10 min
Expanded: 100 um, 50 um, 25 um, 20 um, 2 um, 0.05 um and 1 degree can be added.
Measuring unit input resolution or higher and diameter display
A/B quadrature signal, Z signal (Conforms to EIA-422.)
Measuring unit disconnected, Excess speed, Maximum display amount exceeded,
Power failure, Error in stored data
It is possible to store/call 3 kinds of numbers.
The reference point of the measuring unit can be detected, and the datum point
can be relocated (during connection of measuring unit with a reference point)
The value displayed before the power was turned off and setting values are stored
A fixed compensation is applied to the measuring unit's count value.
Compensation amount Standard: ±600 um/m (Expanded: ±1000 um/m)
The display is turned off when no operations are made for a preset time.
DC 12 V Rating 0.75 A Max. 1 A
AC 100 to 240 V ±10% (When using AC adaptor which is sold separately.)
Max. 32 VA (connected at AC power supply)
0 to 40°C (no condensation)
_20 to 60°C (no condensation)
LH70-1 LH70-2
1-axis 2-axis
Displays coordinates for opening equidistant holes along the
–
–
2-axis display (2-axis or 3-axis input)
2-axis addition display is available
The displayed value can be held and the tool coordinate entered.
LH70-2
SJ300 Series (Direct),
is sold separately.)
(except for angle display)
100 ns
±1 count
(The time can be set.)
Approx. 1.5 kg
10
perimeter of a designated diameter
Display coordinates for simple R cutting
LH70-3
12
LH70-3
LH70-3
3-axis
11-1
(E)