4. Installation and Connection of Unit
Connections when using the addition function with lathe function
Screw down firmly.
To the first axis
Clamp cable to prevent
*1
To the
connector from pulling out.
second or
Make sure that force is not
third axes
being applied to connector.
*1
Measuring unit
Z
-axis
2
X-axis
*1 If the resolutions of the measuring units performing the addition (Z
to connect the measuring unit with higher resolution to the second axis of the counter unit.
Example: Using measuring unit Z
Measuring unit Z
Measuring unit Z
4-4
(E)
First axis
Measuring unit input
DC output connector
To the second
or third axes
Ground
wire
Z
-axis
1
PSC-21/22/23 AC adaptor (sold separately)
100 - 240 VAC± ± ± ± ± 10% 50/60 Hz
* Get power from lamp line.
(resolution: 0.5 um) and measuring unit Z
1
(resolution: 0.5 um) : Connected to counter unit second axis
1
(resolution: 1 um)
2
2
3
M4 x x x x x 16 anchor bolts, 2 pcs.
(supplied)
-axis, Z
-axis) are different, be sure
1
2
(resolution: 1 um)
2
: Connected to counter unit third axis
Bracket
LH70