Use As A Hedge Trimmer; Cleaning/Maintenance; Cleaning & Maintenance; Storage - Parkside PGSA 4 A2 Originalbetriebsanleitung

1. Operate the unlocking mechanism (4)
and turn the cutter head (1) into the
desired position.
2. Release the unlocking mechanism (4)
so that the cutter head (1) locks into
place.

Use as a hedge trimmer

• Move the unit forward evenly.
• The double-sided cutting heads enable
cutting in both directions or by swing-
ing the unit from side to side.

Cleaning/Maintenance

Leave any work not covered
in this manual to our Service
Centre. only use original
parts. There is a risk of injury!
Ensure that the safety key (
removed before all tasks.
Never use cleaning agents or sol-
vents, which can cause irreparable
damage to the unit. Chemicals can
attack the plastic components on
the unit.
Wear gloves when handling the
blades (
of injury from cuts!
Clean and service the unit regularly as fol-
lows. This guarantees a long life for your
unit:
• Check the covers and guards for dam-
age and correct position. If necessary,
replace.
• Never operate the machine with defec-
tive guards or covers or without protec-
tion or with damaged or worn cables.
10/12). There is a risk
• Keep the ventilation slits, motor housing
and handles on the equipment clean. To
do this, use a damp cloth or brush.
• Always keep the blade clean.
After using the equipment, it is impera-
tive to:
- Clean the blade
(with an oily cloth);
- Oil the blade shaft
with an oil can or
spray.
• Slight notches on the
blades can be evened
out. For this, sand
down the blades with an oil stone.
Only sharp blades can cut properly.
• Blunt, bent or damaged blades must
be changed.
We are not liable for damage caused by
the use of the unit if the original cause was
7) is improper repair or the use of non-original
parts or through use other than that desig-
nated in this manual.

Storage

• Keep the equipment in the blade guard
supplied, dry and out of reach of chil-
dren.
• Store the battery only in a partially
charged state. The state of charge
should be 40 – 60 % over a longer
storage period.
• Store the equipment between 10° C and
25° C. During storage, avoid extreme
cold or heat so the battery does not lose
power.
• During a longer storage period, check
the state of charge of the battery and
recharge if necessary roughly every
3 months.
GB MT
67