Milling Operation; Fitting The Copy Sleeve; Milling With The Copy Sleeve; Milling With The Rip Fence - Parkside POF 1200 D3 Originalbetriebsanleitung

Milling operation

Adjust the desired milling depth as described
above.
♦ Place the appliance onto the workpiece and
switch it on.
♦ Release the clamping lever
clockwise and pushing the appliance down-
wards until the depth stop
stop .
♦ Lock the appliance by turning the clamping
lever anticlockwise.
♦ Carry out the milling process at a uniform speed
and contact pressure.

Fitting the copy sleeve

♦ Fit the copy sleeve
below.
♦ Fasten the copy sleeve
using the two screws
adapter.
Ensure that you insert the copy sleeve
right way around – the race
downwards (see fig. C).

Milling with the copy sleeve

NOTE
► The template must be at least as high as the
race of the copy sleeve
► Select a smaller cutter than the inner diameter
of the copy sleeve.
You can use a copy sleeve
onto the workpiece.
♦ Place the router with the copy sleeve on the
template.
♦ Release the clamping lever
clockwise and lower the appliance until the
previously set milling depth is reached.
♦ Now guide the appliance around the template
with the copy sleeve protruding. Do not exert
excessive pressure when working.
POF 1200 D3
by turning it
sits on the step
into the skid plate from
onto the base plate
of the dust extraction
the
must be facing
.
to transfer templates
by turning it

Milling with the rip fence

♦ Push the rip fence
dimension into the guide rails
plate and tighten the locking screws
♦ Place the rip fence
workpiece (see Fig. E).
Adjusting the rip fence (fig. H)
Changing the width of the sliding jaws
♦ Loosen the screws for the sliding jaws
standard Phillips screwdriver (not supplied).
♦ Move the sliding jaws as desired.
♦ Retighten the screws for the sliding jaws
Fine adjustment of the rip fence
♦ Undo the fixing wing screw
♦ Turn the dial to set the desired distance. One
turn corresponds to 1 mm. You can also read
the distance on the scale
less than 1 mm, you can orient yourself using
the freely rotating scale ring
♦ Retighten the fixing wing screw

Milling with a compass

♦ To do this, slide the rip fence
180° (see fig. G) into the guide rails
base plate according to the required dimen-
sion.
♦ Tighten the locking screws
♦ Set the centring point
and tighten it using the wing screw (see fig. G).
Counter the centring point
the oblong hole of the open-ended spanner
♦ Stab the centring point
centre point of a circle.
♦ Check the setting by means of a practical test.
according to the required
on the base
.
onto the edge of the
with a
.
.
. To set values of
.
.
turned by
on the
.
into the rip fence
to tighten it using
into the marked
GB │ IE │
23
.
■