Reducer
Connecting
♦
Push the reducer
adapter
.
♦
Push the hose of a suitable of vacuum cleaning
appliance (e.g. a workshop vacuum) onto the
reducer
.
Removal
♦
Pull the hose of the vacuum cleaner off the
reducer
.
♦
Remove the reducer
Changing the collet chuck
NOTE
►
All of the cutters in the supplied cutter set are
equipped with an 8 mm shank.
Use the pre-assembled collet chuck
with them. When using milling cutters with a
6 mm shank, replace the collet chuck as
described below.
♦
Press the spindle locking button
down.
♦
Undo the union nut anticlockwise with the open-
ended spanner
mm) can be removed.
♦
Fit the collet chuck
ATTENTION! Do not tighten the union nut
with the open-ended spanner
tool is fitted. Otherwise, the collet chuck may be
damaged.
♦
Release the spindle locking button
Fitting the rip fence
♦
Undo the wing screws
♦
Push the sliding rods
openings next to the wing screws. Retighten the
wing screws
for the sliding rods.
POF 1200 D3
into the dust extraction
.
(8 mm)
and hold it
until the collet chuck
(6 mm).
unless a milling
.
for the sliding rods.
into the corresponding
Setting up
Switching on and off
Switching on
♦
Press the safety lock-out
♦
Press the ON/OFF switch
machine is running, you can release the safety
lock-out
Switching off
♦
Release the ON/OFF switch
Preselecting the rotation speed
♦
Set the required speed using the adjusting
wheel for speed preselection
1–2 = low speed
3–4 = average speed
5–7 = high speed
Setting the milling depth
♦
Make sure that the clamping lever
If it is released, turn it anticlockwise until it is
locked.
♦
Place the appliance onto the workpiece.
♦
Rotate the step stop
(8
lowest position (0 mm).
The depth stop
position (0 mm).
♦
Undo the locking screw
♦
Release the clamping lever
clockwise and pushing the appliance down-
wards until the milling machine is touching the
surface of the workpiece.
♦
Lock the clamping lever
clockwise.
♦
Slide the depth stop
reaches the lowest position (0 mm) of the step
stop
.
♦
Set the depth stop
depth, tighten the locking screw
and hold it down.
. Once the
.
.
.
until it engages in the
is now in line with the lowest
.
by turning it
by turning it anti-
downwards until it
to the desired milling
GB │ IE
is locked.
.
│
21
■