Herunterladen Inhalt Inhalt Diese Seite drucken

Hitachi N45AE Bedienungsanleitung Seite 8

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 10
English
Nail Guide
(2) Open the nail guide and remove dust, etc., as shown
in Fig. 14. Apply lubricant to the sliding groove of the
feeder and feeder shaft. Check the main nail stopper
and sub nail stopper slide smoothly by pushing them
with your finger.
Main Nail Stopper
Nail Guide
Sub Nail Stopper
Feeder
(3) Also, apply the recommended oil to the feeding sur-
face of the nose and nail guide after cleaning. This
promotes smooth operation and retards corrosion.
CAUTION:
Check for smooth movement of the feeders and
stoppers before use. If movement is uneven, nails
could be fired at an irregular angle, presenting a
hazard to the operator and others nearby.
5. Cleaning and removal of tar and dirt
Adhesion of tar and dirt to areas around the discharge
outlet, push lever or nail feed parts will interfere with
proper operation.
Please clean and remove tar and dirt with kerosene, #2
fuel oil or diesel fuel.
CAUTION
Never use gasoline or other similar highly volatile
liquids for cleaning. Vapors of such liquids inside the
power tool could be ignited by sparks produced during
nailing and cause an explosion.
Never use kerosene to oil the tool.
(1) Please immerse only the area around the discharge
outlet in solvent and do not immerse the cylinder or
magazine.(See Fig. 15)
7
Knob
Fig. 13
Nose
Feeder Shaft
Fig. 14
Body
Nose
Push
Lever
CAUTION
Do not immerse the nailer in solvent. Plastic parts and
the O-ring etc. may be demaged.
(2) Throughly dry the power tool. If any oily film from the
solvent remains, it will promote adhesion of tar and
frequent cleaning will be necessary.
(3) After cleaning check that the push lever, the spring to
return the push lever, and the feeder move smoothly.
CAUTION
The push lever must be free to move without sticking
or binding. The spring must positively return the push
lever to its down position whenever the push lever is
released from being held in its up position.
6. Inspecting the magazine
Clean the magazine. Remove dust of wooden chips
which may have accumulated in the magazine.
7. Storing
When not in use for an extended period, apply a thin
coat of the lubricant to the steel parts to avoid rust.
Do not store the Nailer in a cold weather environment.
Keep the Nailer in a warm area.
When ot in use, the Nailer should be stored in a warm
and dry place.
Keep out of reach of children.
8. Service parts list
A : Item No.
B : Code No.
C : No. Used
D : Remarks
CAUTION:
Repair, modification and inspection of Hitachi Power
Tools must be carried out by an Hitachi Authorized
Service Center.
This Parts List will be helpful if presented with the tool
to the Hitachi Authorized Service Center when re-
questing repair or other maintenance.
In the operation and maintenance of power tools, the
safety regulations and standards prescribed in each
country must be observed.
MODIFICATIONS:
Hitachi Power Tools are constantly being improved
and modified to incorporate the latest technological
advancements.
Accordingly, some parts (i.e. code numbers and/or
design) may be changed without prior notice.
Magazine
Outlet
Fig. 15

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Nv45ae

Inhaltsverzeichnis