Electrical Connection; Connect Vent; Complete Installation; Maintenance Instructions - Whirlpool 3LCED9100 Installationsanleitung

Electrical Connection

WARNING
Electric Shock Hazard
This is a 3-wire dryer which must be earthed.
Securely tighten all electrical connections.
Failure to do so can result in death, re, or
electric shock.
This dryer is supplied without an electric cord and plug;
it must be connected by a competent electrician.
See "Electrical Requirements".

Maintenance instructions:

Clean lint screen after each cycle.
I
Removing accumulated lint (disconnect dryer from electricity
I
supply before starting this task):
From inside the dryer cabinet:
•
Lint should be removed every 2 years or more often,
depending on dryer usage. Cleaning should be done
by a qualified person.
From the exhaust vent:
•
Lint should be removed every 2 years, or more often,
depending on dryer usage.
If you need further assistance, you can contact the dealer/
distributor where the dryer was purchased.
When you call, you will need the dryer model number and serial
number. Both numbers can be found on the serial-rating plate
located on your dryer.
For Warranty Terms and Conditions, contact the dealer/distributor.
8
MAINTENANCE INSTRUCTIONS

ASSISTANCE OR SERVICE

Connect Vent

1. Using a 102 mm (4") clamp, connect vent to exhaust outlet
in dryer. If connecting to existing vent, make sure the vent is
clean. The dryer vent must fit over the dryer exhaust outlet
and inside the exhaust hood. Make sure the vent is secured
to exhaust hood with a 102 mm (4") clamp.
2. Move dryer into final position. Do not crush or kink vent.
Make sure dryer is level.

Complete Installation

1. With dryer in final position, place level on top of the dryer,
first side to side; then front to back. If the dryer is not level,
adjust the legs of the dryer up or down until the dryer is level.
2. Switch on power supply.
3. Check dryer operation:
Press the selection button for a full cycle and let the dryer run
for at least five minutes. Dryer will stop when time is used up.
NOTE: Dryer door must be closed for dryer to operate.
When door is open, dryer stops, but timer continues to run.
To restart dryer, close door and press a cycle button.
4. Start the dryer and allow it to complete a full cycle to make
sure it is working properly.
If dryer does not operate, check the following:
Electric supply is connected.
I
Circuit breaker is not tripped or fuse is not blown.
I
Door is closed. Listen closely to hear door switch(es) activate.
I
Selected cycle button has been pressed firmly and display
I
shows cycle time.