Information About Recycling And Disposal; Eu Declaration Of Conformity - Parkside 120 A2 Montage-, Bedienungs- Und Sicherheitshinweise

... / Information about recycling and disposal / EU Declaration of Conformity
outlet to ensure the tool is safely
isolated from the power supply.
Clean the exterior of the welding
„
device and its accessories regularly.
Use compressed air, cotton waste or
a brush to remove dirt and dust.
Note: The following kinds of mainte-
nance work must be performed only by
suitably-qualified personnel.
The current regulator, earthing
„
device, internal cables, the coupling
device of the welding torch and
adjusting screws must be serviced
regularly. Re-tighten loose screws
and replace rusty screws (replace-
ment M4x10 screws are available in
any commercial hardware store).
Check the insulation resistance levels
„
of the welding device regularly.
To do this use an appropriate
measuring device.
In case of a defect or a necessary
„
replacement of equipment parts,
please contact the appropriate
qualified personnel.
z Information about
recycling and disposal
Don't throw away – recycle
Please return this device, accesso-
ries and packaging to your local
recycling depot.
According to European Directive
2012/19/EU, used electrical devices
must be collected separately for envi-
ronmentally compatible recycling or
recovery. Please return this device to an
approved waste management company
or use your municipal waste collection
service. Please ensure you comply with
local regulations. If you have any ques-
tions, please contact your local authority
or waste management company.
z EU Declaration of
Conformity
We,
C.M.C. GmbH
Responsible for documentation:
Dr Christian Weyler
Katharina-Loth-Str. 15
66386 St. Ingbert
Germany
hereby take sole responsibility for
declaring that the product
Inverter welder
Art. no.:
Year of manufacture: 2020/18
IAN:
Model:
meets the basic safety requirements as
specified in the European Directives
EC low-voltage directive:
2014/35/EU
EC Guideline on Electromagnetic
Compatibility:
2014/30/EU
RoHS directive:
2011/65/EU+2015/863/EU
and the amendments to these Directives.
The object of the declaration described
above meets the requirements of
Directive 2011/65/EU of the European
Parliament and of the Council of
8 June 2011 on the restriction of the
use of certain hazardous substances in
electrical and electronic equipment.
This conformity assessment is based on
the following harmonised standards:
2249
331996_1907
PISG 120 A2